|
Operating
Flow：
-
Manually put the sheet
upon the clamp frame and push the switch to
start, then the sheet will be fixed by the
clamp frame edge. The clamp frame will drive
the sheet into one heating area;
simultaneously, another clamp frame is
driven back forward to the forming area for
the proceed of blowing, forming and cooling.
End the action of producing, clamp system
automatically open and the operator or the
robot can remove the product from the
forming area. Then putting a new sheet onto
the frame again and push the switch to start
next cycle.
Machine
Feature：
-
This machine has
constructed with two heating station A & C
at each side of the machine and one forming
station B. When B is working, A or C is
working, too. Therefore, operation time can
be decreased and output can be increased. So
heater control system adopt PID correspond
temperature controller with SSR heater
control. When temperature reaches to pre-set
range, it can only top up power supply to
reduce the electric current.
|
Material：
Optional
Accessory：
-
Compressor：Motor Power：15HP
-
Oil cycle vacuum pump：
1. 7.5/9.0KW, MV, 50/60HZ, 3PH
x 1
2. Exhaust capacity
300/360m3/hr at 50/60HZ
3. Vacuum 0.5 or 0.1 mbar
-
Ice/Hot dual purpose mold
temperature controller
|
1. Softened water
supply.
2. Minimum working
temp：8℃~120℃
3. Hot water pump motor power：3HP motor
4. Hot water pump flow pressure：
Max.
flow：224L/min；Max. pressure：2.9kg
5. Ice water pump：3HP high pressure motor
6. Ice water pump flow pressure：
Pressure at 3.0, 100L/min.
7. Compressor horse power：5HP x2
8. Freezing capacity：30240kcal/h/10℃ |
|
